Prolonged and repeated contact with mineral oil will result in the removal of natural fats from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
Adequate means of skin protection and washing facilities should be provided.
Care should be taken, therefore, when changing engine oil, to minimize the frequency and length of time your skin is exposed to used engine oil. Protective clothing and gloves, that cannot be penetrated by oil, should be worn. The skin should be thorougthly washed with soap and water, or use waterless hand cleaner, to remove any used engine oil.
Do not use gasoline, thinners, or solvents.
In order to preserve the environment, used oil and used oil filters must be disposed of only at designated disposal sites.
1.DRAIN ENGINE OIL
Remove the oil filler cap.
Remove the oil drain plug, and drain the oil into a container.
2.REPLACE OIL FILTER
Using SST, remove the oil filter.
Clean and check the oil filter installation surface.
Apply clean engine oil to the gasket of a new oil filter.
Lightly screw the oil filter into place, and tighten it until the gasket contacts the seat.
Using SST, tighten it additional 3/4 turn.
3.FILL WITH ENGINE OIL
Clean and install the oil drain plug with a new gasket.
350 kg*cm (25 ft*lb, 34.3 N*m)
Add fresh oil and install the oil filler cap assembly.
| Oil Grade | Oil Viscosity (SAE) |
|---|---|
| API CF-4, CF or ACEA B3, B4, B5 or JASO DL-0 | ·
5W-30 ·
10W-30 |
| Item | Fill amount |
|---|---|
| Drain and refill with oil filter change | 9.8 liters (10.4 US qts, 8.6 Imp. qts) |
| Drain and refill without oil filter change | 8.5 liters (9.0 US qts, 7 .5 Imp. qts) |
| Dry fill | 10.1 liters (10.7 US qts, 8.9 Imp. qts) |
4.START ENGINE AND CHECK FOR LEAKS
5.RECHECK ENGINE OIL LEVEL