Prolonged and repeated contact with engine oil will cause removal of natural oils from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
Precautions should be taken when replacing engine oil to minimize the risk of your skin making contact with used engine oil. Wear protective clothing and gloves. Wash your skin thoroughly with soap and water, or use a waterless hand cleaner to remove any used engine oil. Do not use gasoline, thinners or solvents.
For environmental protection, used oil and used oil filters must be disposed of at designated disposal sites.
58410
1.REMOVE ENGINE SERVICE HOLE COVER
58734B
2.REMOVE REAR ENGINE SERVICE COVER WEATHERSTRIP
58521D
3.REMOVE ENGINE SERVICE HOLE COVER MAT
58420
4.REMOVE NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY
5.DRAIN ENGINE OIL
Remove the oil filler cap.
Remove the oil drain plug and drain the oil into a container.
Clean and install the oil drain plug with a new gasket.
38 N*m (382 kgf*cm, 28 ft.*lbf)
15601
6.REMOVE OIL FILTER SUB-ASSEMBLY
Using SST, remove the oil filter.
15601
7.INSTALL OIL FILTER SUB-ASSEMBLY
Check and clean the oil filter installation surface.
Apply clean engine oil to the gasket of a new oil filter.
Lightly screw the oil filter into place by hand. Tighten it until the gasket contacts the seat.
Using SST, tighten the oil filter.
Depending on the work space available, choose from the following.
If enough space is available, use a torque wrench to tighten the oil filter.
17 N*m (175 kgf*cm, 13 ft.*lbf)
If enough space is not available to use a torque wrench, tighten the oil filter a 3/4 turn by hand or use a common wrench.
8.ADD ENGINE OIL
Add fresh oil and install the oil filler cap assembly.
| Oil Grade | Oil Viscosity (SAE) |
|---|---|
| API grade SL "energy-conserving", SM "energy-conserving", SN "resource-conserving", SN PLUS "resource-conserving" or SP "resource-conserving", or ILSAC GF-6A multigrade engine oil | ·
0W-20 ·
5W-20 ·
5W-30 ·
10W-30 |
| Item | Fill amount |
|---|---|
| Drain and refill with oil filter change | 6.0 liters (6.3 US qts, 5.3 Imp. qts) |
| Drain and refill without oil filter change | 5.4 liters (5.7 US qts, 4.8 Imp. qts) |
| Dry fill | 6.3 liters (6.7 US qts, 5.5 Imp. qts) |
9.INSPECT FOR ENGINE OIL LEAK
Start the engine, and check that there are no oil leaks after performing maintenance.
58420
10.INSTALL NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY
58521D
11.INSTALL ENGINE SERVICE HOLE COVER MAT
58734B
12.INSTALL REAR ENGINE SERVICE COVER WEATHERSTRIP
58410
13.INSTALL ENGINE SERVICE HOLE COVER