Home › General › INTRODUCTION › WORK NOTICES AND PRECAUTIONS
BM24M0E _V1 General _059851 INTRODUCTION _0293729 WORK NOTICES AND PRECAUTIONS F

INTRODUCTION  WORK NOTICES AND PRECAUTIONS  PRECAUTIONS FOR REPAIRING BODY STRUCTURE (INCLUDING CRUSH BOXES)  


PROHIBITION OF HEAT REPAIR FOR BODY FRAME PARTS


a.
K110065

Rustproof high strength steel sheets are used for the body frame. Therefore, if these parts are heat repaired using an acetylene torch or equivalent, the crystalline structure changes, causing the strength of the steel sheets to decrease. Also, the zinc coating which is used to protect the body from rust will be damaged. This causes the surface of the steel sheets to become oxidized, which reduces their ability to resist rust.



WHEN TO REPLACE FRAME PARTS


K110068

NOTICE:

Replace the sections of the frame where kinks have occurred.


HINT:
What is kink?

A deformation on a steel sheet that cannot be returned to its original shape by pulling or hammering due to the deformation angle being sharp.




REPAIR OF DOOR SIDE IMPACT BEAM IS PROHIBITED


a.
K110069

K110070

The impact beam is designed so that it performs at 100% in its original shape. However, if the impact beam is repaired, its performance may not be the same as before the accident.

PARTS WHICH ARE PROHIBITED TO BE REPAIRED:

Door side impact beam




REPAIR OF BUMPER REINFORCEMENT IS PROHIBITED


a.
K110071

The bumper reinforcement is designed so that it performs at 100% in its original shape. However, if the bumper reinforcement is repaired, its performance may not be the same as before the accident.

PARTS WHICH ARE PROHIBITED TO BE REPAIRED:

Bumper reinforcement