With the cowl top side upper panel removed.
REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Remove Weld Points |
|
Cut and Join Location |
|
Cut Location for Supply Parts |
| *a | mm (in.) | - | - |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Plug Weld |
|
Plug Weld |
|
Cut and Join Location |
|
Butt Weld |
Before temporarily installing the new parts, weld the rocker panel no.2 reinforcement, front body pillar lower reinforce and cowl side panel with the standard number of welding points.
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
After welding the rocker panel no. 2 reinforcement, front body pillar lower reinforce and cowl side panel to the vehicle side, install the front pillar and rocker outer panel.
After welding, apply the foamed sealing material to the corresponding parts. (See the painting / coating)
After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.
| *1 | Cowl Side Panel | *2 | Rocker Panel No.2 Reinforcement |
| *3 | Front Body Pillar Lower Reinforce | - | - |
| *a | mm (in.) | - | - |
| *1 | Cowl Side Panel | *2 | Front Body Pillar Lower Reinforce |
| *3 | Rocker Panel No.2 Reinforcement | *4 | Front Pillar |
| *5 | Rocker Outer Panel | - | - |