After using a degreasing agent to clean the surfaces of the body where the caution labels will be attached, attach the caution labels to the positions shown in the illustration.
Make sure the caution label is not attached over a spot weld.
When attaching the caution label, make sure not to touch the label's adhesive surface.
To prevent the edges of the caution label from peeling, apply extra pressure to the label's periphery.
If the work area's temperature is 5°C or less, the caution label's adhesive will deteriorate. It is recommended that you heat the label to 20 to 40°C.
| *1 | LLC Label | *2 | Engine Service Information Label |
| *1 | Door Caution Label | *2 | Slide Door Caution Label |
| *3 | Side A/B Caution Label (Middle east, GENERAL EXPORT LHD) | *4 | Name Label (CHINA) |
| *5 | Side A/B Caution Label (CHINA) | *6 | Side A/B Caution Label (Australia, Newzealand, GENERAL EXPORT) |
| *7 | Compliance Plate (Australia, Newzealand) | *8 | Name Label (Australia, Newzealand) |
| *9 | Tire Pressure Information Label (CHINA) | *10 | Name Label (Middle east, GENERAL EXPORT) |
| *11 | Tire Pressure Information Label (Middle east, GENERAL EXPORT) | *12 | Side A/B Caution Label (Australia, Newzealand) |
| *13 | Identification Number Plate (CHINA, Middle east) | *14 | Fuel Information Label |
| *A | Power Back Door Only | - | - |
| *1 | Child Protector Label | *2 | Reflex Reflector |
| *3 | Power Back Door Caution Label | - | - |