Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS
BM24M0E _V1 General _059851 INTRODUCTION _0293783 WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS  REPAIR PROCEDURE OF HEADLIGHT ASSEMBLY  


HINT:
·

If the installation area of the headlight assembly is damaged, use the supply bracket for low-cost repair.

·

Ensure that the headlight assembly is not damaged.



INSTALL UPPER HEADLIGHT PROTECTOR RETAINER


a.
E185583

Cut off the part shaded in the illustration and smooth with sandpaper.

NOTICE:

After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply bracket.



b.
E310340

Install the upper headlight protector retainer with the 2 screws.



INSTALL UPPER NO. 2 HEADLIGHT PROTECTOR RETAINER


a.
E136825

Cut off the part shaded in the illustration and smooth with sandpaper.

NOTICE:

After cutting off the part, place the upper No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply bracket.



b.
E136826

Install the upper No. 2 headlight protector retainer with the 2 screws.