Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS
BM24M0E _V1 General _059851 INTRODUCTION _0293783 WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS  PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED  


Refer to the TOYOTA Repair Manual for each work procedure.

PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Procedures necessary when battery terminal is disconnected / reconnected
Necessary Procedures Procedure Details Effects / Inoperative Functions When Necessary Procedures are not Performed Note
w/ AFS: Store steering angle sensor neutral point Drive the vehicle at more than 20 km/h (12mph) for more than 5 minutes on a straight road, with as little traffic congestion as possible. AFS Neutral point storage may also be performed manually
w/ Parking Assist Monitor System: Store steering angle neutral point When steering wheel is turned fully to the left and right while driving on a flat, level road, the steering angle neutral point is corrected.
·

Parking Assist Monitor System

·

Multi-display indicates "System initializing"


Neutral point storage may also be performed manually
Reset slide door closed position Close the slide door fully to turn off the courtesy switch
·

Power Slide Door

·

Slide Door Closer


If the slide door is closed when disconnecting the cable from the battery terminal, it is not necessary to reset it.
Initialize power back door Close the slide door fully to turn off the courtesy switch
·

Power Back Door

·

Back Door Closer


If the back door is closed when disconnecting the cable from the battery terminal, it is not necessary to reset it.