Home › Vehicle Exterior › BODY PANEL › REAR FLOOR REAR CROSS OUTER PANEL
BM24M0E _01 Vehicle Exterior _059852 BODY WELD POINT _0293788 REAR FLOOR REAR CROSS OUTER PANEL F

BODY WELD POINT  REAR FLOOR REAR CROSS OUTER PANEL  CUT AND JOIN REPLACEMENT SECTIONS (SMALL AREAS)  


K133151

REMOVAL / INSTALLATION


Symbol Meaning
K108818

Remove Weld Points
K108820

Remove Weld Points
K108827

Cut and Join Location
K108823

Plug Weld
K108825

Plug Weld
K108831

Butt Weld

REMOVAL POINT
1.

While paying attention not to damage the rear floor crossmember center plate, cut off the rear floor rear cross outer panel.


INSTALLATION POINT
1.

Inspect the fitting of the related parts around the new parts before welding. This affects the apperance of the finish.

2.

After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)

3.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K133206C01
2.406,2.25 2.625,0.854 false 4.573,3.781 4.271,2.354 false 2.521,8.063 2.854,7.365 false 4.667,8.063 4.281,7.365 false 4.74,2.25 4.594,0.896 false 2.583,0.646 2.896,0.802 0.313,0.156 10 false *1 4.531,3.813 4.844,3.969 0.313,0.156 10 false *2 2.406,8.083 2.719,8.24 0.313,0.156 10 false *3 4.625,8.083 4.938,8.24 0.313,0.156 10 false *4 6.844,8.552 7.156,8.708 0.313,0.156 10 false *a 1.802,0.917 2.5,1.354 0.698,0.438 10 false 170 (6.69) 4.771,0.927 5.5,1.333 0.729,0.406 10 false 170 (6.69) 4.51,0.698 4.823,0.854 0.313,0.156 10 false *1
*1 Rear Floor Crossmember Center Plate *2 Wiring Harness Clamp Bracket
*3 Rear Bumper Cover No.2 Bracket *4 Rear Bumper Cover No.1 Bracket
*a mm (in.) - -