Home › Vehicle Exterior › BODY PANEL › REAR FLOOR REAR INNER CROSSMEMBER
BM24M0E _01 Vehicle Exterior _059852 BODY WELD POINT _0293749 REAR FLOOR REAR INNER CROSSMEMBER F

BODY WELD POINT  REAR FLOOR REAR INNER CROSSMEMBER  CUT AND JOIN REPLACEMENT SECTIONS (LARGE AREAS)  


K133154

With the back door opening side reinforcement removed.


REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108820

Remove Weld Points
K108827

Cut and Join Location

REMOVAL POINT
1.

While paying attention not to damage the rear floor crossmember center plate, cut off the rear floor rear cross outer panel.


K133210C01
2.469,2.635 3,0.917 false 4.698,2.719 3,0.917 false 2.917,0.719 3.229,0.875 0.313,0.156 10 false *1 6.844,8.552 7.156,8.708 0.313,0.156 10 false *a 4.802,0.958 5.479,1.365 0.677,0.406 10 false 170 (6.69) 5.229,5.729 5.948,6.167 0.719,0.438 10 false 100 (3.94)
*1 Rear Floor Crossmember Center Plate - -
*a mm (in.) - -



INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108825

Plug Weld
K108831

Butt Weld

INSTALLATION POINT
1.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

2.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

3.

After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)

4.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K133211