OUTLINE
The highly rigid and compact MacPherson strut with L-shaped lower arms is used.
The suspension geometry has been optimized to realize excellent driving stability and ride comfort.
Excellent vehicle stability has been ensured by optimizing the rolling rigidity.
| *1 | Coil Spring
·
Optimized spring constant |
*2 | Upper Support
·
Optimized characteristics |
| *3 | Shock Absorber
·
Linear Control Valve used |
*4 | Steering Knuckle
·
Optimized characteristics |
| *5 | Lower Arm
·
Optimized characteristics |
*6 | Stabilizer Bushing
·
Optimized characteristics |
| *7 | Stabilizer Bar
·
Optimized characteristics |
- | - |
SPECIFICATION
|
*1: Unloaded Vehicle Condition *2: With 205/65R16 Tire *3: With 215/55R17 Tire |
||
| Type | MacPherson Strut | |
| Tread*1 | mm (in.) | 1570 (61.8)*2, 1545 (60.8)*3 |
| Caster*1 | degrees | 5° 45' |
| Camber*1 | degrees | -0° 10' |
| Toe-in*1 | mm (in.) | 1 (0.039) |
| King Pin Inclination*1 | degrees | 11° 22' |
MAIN FEATURES
Optimized Caster
Optimum caster angle and trail value are featured to provide straight-line stability during low-speed to high-speed ranges and assist steering response during high speed.
Optimized Camber
The front suspension uses negative camber to reduce the ground contact camber angle of the outer wheel at the time of turning (cornering) which is caused when the vehicle posture changes during cornering, thus realizing excellent cornering performance.
Optimized King Pin Offset
A small king pin offset is used and the moment which occurs around the king pin axis is made small in order to realize excellent vehicle stability when braking.
When force (F) is applied to the wheel during braking etc., (F) is applied at the tire center ground contact point (A) and the king pin offset radius (L). The power of (F) multiplied by (L) tries to turn the king pin axis. In this way, making the king pin offset smaller produces smaller moment of the king pin axis to provide excellent vehicle stability during braking.