Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM › 2013.04–2016.05
NM24M0E _56 Audio / Visual / Telematics _061578 PARK ASSIST / MONITORING _0300417 TOYOTA PARKING ASSIST-SENSOR SYSTEM UN GENERAL/CONTROL/DETAILS F

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  GENERAL/CONTROL/DETAILS  GENERAL  


OUTLINE


a.

Front and rear clearance sonar is optional equipment on all models.


b.

This system uses ultrasonic sensors equipped with an indicator and beeping alarm to detect obstacles at the corners in front of the vehicle and at the rear of the vehicle, and provides information to the driver regarding the distance between the sensors and the obstacles and the position of the obstacles.


c.

When an obstacle is detected by the clearance sonar system, the clearance sonar indicator light blinks and the buzzer sounds to alert the driver.


d.

The ultrasonic sensors are provided with a distance calculation function in order to digitalize the signals between the clearance sonar ECU and ultrasonic sensor.



PRECAUTION


a.

The detection function of this system may not operate properly in the following conditions below:

i.

When ice, snow or mud gets on the sensors. If they are removed, the system will work properly.


ii.

When the sensor is frozen. If defrosted, the system will work properly.


iii.

When the sensor is covered with something. If it is removed, the system will work properly.



b.

Especially in cold weather, a malfunction warning screen may appear on the display due to frozen sensors. If the malfunction warning screen appears on the display, be sure to check the sensor. If the malfunction warning screen appears despite no mud, ice or snowflakes on the sensor, the sensor might have malfunctioned.


c.

The following conditions may have an influence on the detection range:

i.

When foreign matter such as snowflakes or mud gets on the sensor.


ii.

When the vehicle is operated under a scorching sun or in a freezing climate.



d.

The system may improperly detect in the following conditions:

i.

When the vehicle is being driven on bumpy road, gravel road, or on grass.


ii.

When the sound of horns from other vehicles, the sound of a motorcycle engine, the sound of air brakes of large truck, or an object that generates ultrasonic waves is in the vicinity of the vehicle.


iii.

When there is a downpour or water is splashing on the vehicle.


iv.

When the vehicle posture tilts significantly.


v.

When an antenna for a wireless transmitter is mounted on the vehicle.


vi.

When the sensors are covered with mud, ice, or snow.


vii.

When the vehicle travels in the direction of a tall curb or square curb.


viii.

When the other vehicles with sonar are in the vicinity of the vehicle.


ix.

When towing hitch is mounted on the vehicle.



e.

There are cases in which the objects listed below cannot be detected:

i.

Thin objects such as wire or rope.


ii.

Objects that absorb sound waves such as cotton or snow.


iii.

Objects that have sharp edges.


iv.

Objects that are short in height.


v.

Objects that are tall and protrude at the top.



f.

Others:

i.

Objects directly underneath the bumpers cannot be detected. Even if objects that are located lower than the sensors or thin stakes are detected once, they might not be detected after the vehicle comes closer to those objects.


ii.

An object might not be detected if it comes too close to the sensors.


iii.

The sensors might not detect properly if they are exposed to strong shocks such as being struck or having objects thrown at them.


iv.

Be careful not to let steam or high-pressure water of car washers or any other water get into the sensor section. When using them, keep them as far away from the sensor section as possible.