Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM
NM24M0E _58 Vehicle Interior _061654 LIGHTING (INT) _0300921 LIGHTING SYSTEM UN GENERAL/CONTROL/DETAILS F

LIGHTING (INT)  LIGHTING SYSTEM  GENERAL/CONTROL/DETAILS  DETAILS  


FUNCTION


a.

Illuminated Entry System

i.

This system is controlled by the main body ECU.


ii.

When any one of the following conditions is satisfied, the illuminated entry system turns ON engine switch illumination*1, key illumination*2, room light, front personal light and bottle holder illumination.

1.

Any door is opened.

2.

The key is in any of the actuation areas*1.

3.

A door is unlocked through a driver door key operation*1 or transmitter operation*2.

4.

All doors are closed and the power source mode is changed from IG-ON to OFF.


*1: Models with Smart Entry and Start System

*2: Models without Smart Entry and Start System


iii.

When any one of the following conditions is satisfied, these lights will fade out.

1.

After continuing to be ON for approximately 15 seconds after all doors have been properly closed.

2.

All doors are closed and all doors are locked.

3.

All doors are closed and the power source mode is changed to ACC or IG-ON.



iv.

A battery saving function is used to automatically turn OFF the engine switch illumination*1, key illumination*2, room light, front personal light and bottle holder illumination when the following condition occurs continuously for over 20 minutes: the key is not in the ignition key cylinder*2 or the power source mode is OFF*1 when any door is either ajar or open.

*1: Models with Smart Entry and Start System

*2: Models without Smart Entry and Start System