CONSTRUCTION
The step-motor is used to actuate the indicators of the speedometer, the tachometer, the fuel gauge and the water temperature gauge. This has resulted in a thinner pointer movement, thus achieving a lightweight and compact construction.
In the step-motor type, when the power to the combination meter is turned ON through the reconnection of the battery terminal, the step-motor initializes once to recognize the zero point of the indicator in relation to the step-motor. However, if the power source mode is changed to IG-ON after 60 seconds or more have elapsed after the initialization, the step-motor initializes again.
| *a | A-A Cross Section | *b | Front |
| *c | Step-motor | *d | Compact Construction |