CONSTRUCTION
Front Seat
The 8-way manual seat is provided for the driver seat as standard equipment on the DX grade.
The 4-way manual seat is provided for the front passenger seat as standard equipment.
The armrests are provided for the both driver and front passenger seats as standard equipment.
The seatback pockets on both the driver and front passenger seats are provided as standard equipment.
Active Head Restraint System
Active head restraints are provided, which move up and forward almost instantly in the event of a rear-end collision when the force of the occupant body is applied to the seat back and reduce the distance between the occupant's head and the head restraint.
The active head restraint consists of the lower unit, cable and upper unit.
When the lower unit built into the seat back is pressed by the occupant's lumbar as the occupant's body slides down during a rear-end collision, the cable is pulled and the head restraint is moved up and forward by the upper unit, reducing the distance between the occupant's head and the head restraint.
Rear No. 1 Seat
Separate seats with ottomans are provided on the 7-passenger models, and a 60/40 split type tip-up seat is provided on the 8-passenger models.
The separate seats with ottomans are standard equipment.
A walk-in function is provided.
An armrest is provided on each side of the seatback.
The seat slide movement is 804.5 mm (31.7 in.) and the seat reclining angle is 72°.
The seats are provided with a lateral slide mechanism. Their lateral slide movement is set to 85 mm (3.3 in.).
The ottoman is provided with longitudinal slide and angle adjustment mechanisms.
The 60/40 split type tip-up seat is standard equipment.
An armrest is provided in the seatback for the center seat.
A walk-in function is provided.
The seat slide movement is 667 mm (26.3 in.) and the seat reclining angle is 74°.
Rear No. 2 Seat
The rear No. 2 seat with a tumble function is standard equipment on all the models.
An L-shaped headrest is used to achieve excellent rearward visibility.
An armrest is provided in the seat back for the center seat.
An under cover and a leg cover are provided behind the seat cushion to ensure a clean look in the tumble mode.
Rear No. 2 Seat with Stowing Function
A 60/40 split type rear No. 2 seat with stowing function is optional equipment on the 2GR-FE engine models for Australia.
L-shaped headrests are used to achieve excellent rearward visibility.
An armrest is provided on the seatback of the center seat.
The seat reclining angle is 78°.