SYSTEM CONTROL
The power window system has the following functions:
| Function | Outline |
|---|---|
| Manual-up-and-down | The manual-up-and-down function causes the window to open or close while the power window switch is being pulled halfway up or pushed halfway down. The window stops as soon as the switch is released. |
| One-touch Auto Up-and-down | The one-touch auto up-and-down function enables the windows of all doors to be fully opened or closed at a touch of the power window switch. |
| Key Off Operation | This function makes it possible to operate the power window for approximately 43 seconds after the power source mode is selected to OFF, if the driver's door and front passenger's door are not opened. |
| Jam Protection | A jam protection function automatically stops the power window and moves it downward if a foreign object gets jammed in any door window during one-touch auto-up operation or manual-up operation. |
| Remote Control | The up-and-down operations of the front passenger door window and the rear door windows can be controlled by operating the power window master switch. |
FUNCTION
JAM PROTECTION FUNCTION
The jam protection function automatically stops the power window and moves it downward if foreign object gets jammed in the door window during one-touch auto-up operation or manual-up operation.
The mechanism uses Hall IC to detect the door glass position and direction of movement.
The power window ECU is built into the power window motor assembly.
The reverse-direction conditions and amount of down movement after jam detection are as follows: The jam protection function operates and lowers the window approximately 50 mm (1.9 in.). After this, if the amount (space) that the door glass is open has not reached approximately 200 mm (7.87 in.), the jam protection function will continue to lower the window until the space is approximately 200 mm (7.87 in.). If the door glass reaches the fully open position before the initial 50 mm (1.9 in.) lowering of the door glass is reached, the jam protection function will stop at that time.
The jammed window detection mechanism consists of a magnet that is provided on the worm gear of the power window motor assembly, the power window ECUs and the Hall IC that are provided on the power window ECU.
The following two factors are used to determine that jamming has occurred.
The Hall IC converts the changes in the magnetic flux that occur through the rotation of the worm gear into block wave signals and outputs them to the power window ECU.
The power window ECU calculates the speed threshold value of the power window motor in accordance with the window glass position, rough road condition, and various operating conditions at the time the power window motor is started. The power window ECU determines that jamming has occurred if the threshold value is exceeded, and retracts the window glass.
If the power window motor assembly and power window regulator assembly are replaced, the window position information stored in the system will be lost, and the system must be initialized. After replacing the above parts, initialize the system by performing the steps described below.
Set the power source mode to IG-ON, and fully open the driver's window. Continue to hold down the switch for at least 1 second after the window has fully opened*.
Hold the AUTO switch in the auto up position. Continue to hold the AUTO switch in the auto up position for approximately 1 second after the window has fully closed. The system will memorize the window's fully closed position as the initial position.
For details, see the Previa/Tarago Repair Manual2A0E).
*: When the window reaches its fully open position, the indicator light will change from flashing to illumination, in order to indicate that the window is in the fully open position. However, this does not indicate that the initialization of the system has been completed.