Home › Engine / Hybrid System › 2GR-FE ENGINE MECHANICAL › ENGINE UNIT › 2013.04–2016.05
NM24M0E _51 Engine / Hybrid System _061728 2GR-FE ENGINE MECHANICAL _0301073 ENGINE UNIT UN GENERAL/CONTROL/DETAILS F

2GR-FE ENGINE MECHANICAL  ENGINE UNIT  GENERAL/CONTROL/DETAILS  GENERAL  


OUTLINE


a.

The newly developed 2GR-FE engine is a 3.5-liter, 24-valve DOHC V6 engine. This engine uses the Dual VVT-i (Variable Valve Timing-intelligent) system, DIS (Direct Ignition System), ACIS (Acoustic Control Induction System), and ETCS-i (Electronic Throttle Control System-intelligent). These control functions achieve improved engine performance, fuel economy, and reduced exhaust emissions.

W135315

W135314



SPECIFICATION


*1: Premium unleaded gasoline with a Research Octane Number 95 or higher required for optimum engine performance. If 95 octane cannot be obtained, you may use unleaded gasoline with a Research Octane Number as low as 91. Use of unleaded fuel with a Research Octane Number lower than 95 may result in engine knocking and significantly reduced performance. Persistent knocking can lead to engine damage and should be corrected by refueling with higher octane unleaded gasoline.

*2: Emission regulations differ depending on the specifications of the vehicle.

*3: Weight shows the figure with the oil and water fully filled.

No. of Cyls. & Arrangement 6-cylinder, V Type
Valve Mechanism 24-valve DOHC, Chain Drive (with Dual VVT-i)
Combustion Chamber Pentroof-type
Manifolds Parallel-flow
Fuel System EFI
Ignition System DIS
Displacement cm3 (cu. in.) 3456 (210.9)
Bore x Stroke mm (in.) 94.0 x 83.0 (3.70 x 3.27)
Compression Ratio 10.8 : 1
Max. Output (SAE-NET) 202 kW @ 6200 rpm
Max. Torque (SAE-NET) 340 N*m @ 4700 rpm
Valve Timing Intake Valve Open -3° to 37° BTDC
Close 71° to 31° ABDC
Exhaust Valve Open 60° to 25° BBDC
Close 4° to 39° ATDC
Oil Capacity Dry liters (US qts, Imp. qts) 6.8 (7.2, 6.0)
With Oil Filter liters (US qts, Imp. qts) 6.1 (6.4, 5.4)
Without Oil Filter liters (US qts, Imp. qts) 5.7 (6.0, 5.0)
Firing Order 1 - 2 - 3 - 4 - 5 - 6
Research Octane Number (RON) 95 or higher*1
Engine Oil Grade API SL, SM, SN or ILSAC
Emission Regulation*2 EURO IV, EURO V
Engine Service Mass*3 (Reference) kg (lb) 163 (359)


MAIN FEATURES


a.

The 2GR-FE engine has achieved the following performance through the use of the items listed below.

(1) High performance and reliability

(2) Low noise and vibration

(3) Lightweight and compact design

(4) Good serviceability

(5) Clean emission and fuel economy

Item (1) (2) (3) (4) (5)
Engine Proper A steel laminate type cylinder head gasket is used. ○
An upright intake port is used. ○ ○
A taper squish shape is used for combustion chamber. ○ ○
A cylinder block made of aluminum alloy is used. ○
The skirt portion of the piston is applied with resin to reduce friction. ○ ○ ○
An oil pan No. 1 made of aluminum alloy is used. ○ ○
Valve Mechanism The Dual VVT-i (Variable Valve Timing-intelligent) system is used. ○ ○
Hydraulic lash adjusters are used. ○ ○ ○
Timing chains and chain tensioners are used. ○ ○ ○
Roller rocker arms are used. ○ ○
Lubrication System An oil filter with a replaceable element is used. ○
Cooling System The TOYOTA Genuine SLLC (Super Long Life Coolant) is used. ○
Intake and Exhaust System The link-less type throttle body is used. ○ ○
The intake air chamber made of plastic is used. ○
A stainless steel exhaust manifold is used. ○ ○
An ultra thin-wall, high-cell density ceramic type TWC (Three-Way Catalytic converter) is used. ○
Fuel System The fuel delivery pipe made of plastic is used. ○
A compact 12-hole type injector is used. ○ ○
Quick connectors are used to connect the fuel hose with the fuel pipe. ○
Ignition System The DIS (Direct Ignition System) makes ignition timing adjustment unnecessary. ○ ○ ○
The long-reach type spark plugs are used. ○
Charging System A segment conductor type alternator is used. ○ ○
An alternator pulley with a clutch is used. ○
Starting System The PS (Planetary reduction-Segment conductor motor) type starter is used. ○
Serpentine Belt Drive System A serpentine belt drive system is used. ○ ○
Engine Control System The MRE (Magnetic Resistance Element) type VVT sensors are used. ○
The ETCS-i (Electronic Throttle Control System-intelligent) is used. ○ ○
The ACIS (Acoustic Control Induction System) is used. ○ ○
The charging control is used. ○