CONSTRUCTION
Exhaust Manifold
A stainless steel exhaust manifold with an integrated TWC (Three-Way Catalytic converter) is used for warm-up of the TWC and for weight reduction.
An ultra thin-wall, high-cell density, ceramic type TWC is used. This TWC is incorporated on each of the right and left banks.
This TWC reduces exhaust emissions by optimizing the cells density and the wall thickness.
| *1 | TWC | *2 | Right Bank Exhaust Manifold |
| *3 | Left Bank Exhaust Manifold | - | - |
| *a | Ultra Thin-Wall | - | - |
Exhaust Pipe
The exhaust pipe is made of stainless steel for improved rust resistance.
A thin-wall, ceramic type TWC is used.
Ball joints are used at two places: one at the exhaust center pipe joint, and the other between the exhaust center pipe and the tailpipe. As a result, a simple construction and reliability are realized.
| *1 | Exhaust Front Pipe | *2 | Ball Joint |
| *3 | TWC | *4 | Exhaust Center Pipe |
| *5 | Sub Muffler | *6 | Tailpipe |
| *7 | Main Muffler | *8 | Spring |
| *9 | Bolt | *10 | Gasket |