OUTLINE
The cooling system is a pressurized, forced-circulation type.
A thermostat with a bypass valve is located on the water inlet housing to maintain suitable temperature distribution in the cooling system.
A cooling fan control system in which the engine ECU optimally controls cooling fan speed is used. For details, click here Engine / Hybrid System>2GR-FE ENGINE CONTROL>SFI SYSTEM>DETAILS.
An air bleeder plug is provided on the water inlet assembly to improve the efficiency of changing the water. For details, refer to the Repair Manual.
The TOYOTA genuine SLLC (Super Long Life Coolant) is used.
| *1 | Air Bleeder Plug | *2 | Thermostat |
| *a | To Throttle Body | *b | From Throttle Body |
| *c | To Heater | *d | From Heater |
| *e | To Radiator | *f | From Radiator |
SPECIFICATION
| Engine Coolant | Type | TOYOTA genuine Super Long Life Coolant (SLLC) or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite and non-borate coolant with long-life hybrid organic acid technology (coolant with long-life hybrid organic acid technology is a combination of low phosphates and organic acids.) Do not use plain water alone. | ||
| Color | Pink | |||
| Capacity | Except Towing Package Models | With Rear Heater | 10.6 Liters (11.2 US qts, 9.3 Imp. qts) | |
| Without Rear Heater | 8.7 Liters (9.2 US qts, 7.7 Imp. qts) | |||
| Towing Package Models | With Rear Heater | 10.9 Liters (11.5 US qts, 9.6 Imp. qts) | ||
| Without Rear Heater | 9.1 Liters (9.6 US qts, 8.0 Imp. qts) | |||
| Maintenance Intervals | First time | 160,000 km (100,000 miles) | ||
| Subsequent | Every 80,000 km (50,000 miles) | |||
| Thermostat | Opening Temperature | 80 °C to 84 °C (176 °F to 183 °F) | ||
SLLC is pre-mixed (50 % coolant and 50 % deionized water). Therefore, no dilution is needed when SLLC in the vehicle is added or replaced.
If LLC is mixed with SLLC, the interval for LLC (every 40,000 km / 24,000 miles or 24 months whichever come first) should be used.