Home › Engine / Hybrid System › 2GR-FE LUBRICATION › LUBRICATION SYSTEM
NM24M0E _51 Engine / Hybrid System _061732 2GR-FE LUBRICATION _0301084 LUBRICATION SYSTEM UN GENERAL/CONTROL/DETAILS F

2GR-FE LUBRICATION  LUBRICATION SYSTEM  GENERAL/CONTROL/DETAILS  DETAILS  


CONSTRUCTION


a.

Oil Pump

i.

A compact cycloid rotor type oil pump directly driven by the crankshaft is used.


ii.

This oil pump has used an internal relief method which circulates relief oil to the suction passage in the oil pump. This aims to minimize oil level change in the oil pan, reduce friction, and reduce air mixing rate in the oil.

W135287C01
4.417,0.479 6.917,2.896 2.5,2.417 1,1 0.75,0.5 0.75,0.5 0.5,0.5 true 2.583,2.333 2.5,2.75 2.5,2.75 2.333,2.75 true 3,1.583 2.833,1.25 2.833,1.25 2.583,1.25 true 3.667,2.417 3.5,3 3.5,3 3.25,3 true 0.333,0.396 0.531,0.604 0.198,0.208 10 false *1 2.146,2.646 2.354,2.833 0.208,0.188 10 false *2 2.396,1.156 2.583,1.344 0.188,0.188 10 false *3 3.063,2.906 3.26,3.115 0.198,0.208 10 false *4 4.458,0.521 4.656,0.729 0.198,0.208 10 false *a 5.969,0.885 6.177,1.083 0.208,0.198 10 false *b 4.99,2.531 5.188,2.708 0.198,0.177 10 false *c 5.198,2.542 5.396,2.729 0.198,0.188 10 false *d 6.021,2.604 6.208,2.813 0.188,0.208 10 false *e
*1 Timing Chain Cover *2 Oil Pump Rotors (Cycloid Rotor)
*3 Oil Pump Housing *4 Crankshaft
*a Oil passage in the oil pump *b To Cylinder Block
*c From Oil Filter *d To Oil Filter
*e From Oil Strainer - -




b.

Oil Jet

i.

Oil jets for cooling and lubricating the pistons have been provided in the cylinder block, in the center of the right and left banks.


ii.

These oil jets contain a check valve to prevent oil from being fed when the oil pressure is low. This prevents the overall oil pressure in the engine from dropping.

W135288C01
4,0.667 7,3.083 3,2.417 0.333,1 0.5,1 0.5,1 1.333,1.833 true 1.052,3.479 1.219,3.479 1.219,3.479 2.052,1.979 true 1.667,3.542 1.833,3.542 1.833,3.542 2.417,1.958 true 4.604,1.302 4.938,1.302 4.938,1.302 5.688,1.969 true 0.146,0.896 0.333,1.104 0.188,0.208 10 false *1 4.427,1.198 4.615,1.417 0.188,0.219 10 false *2 4.063,0.729 4.271,0.948 0.208,0.219 10 false *a 5.615,1.208 5.833,1.396 0.219,0.188 10 false *b 0.875,3.375 1.063,3.583 0.188,0.208 10 false *1 1.5,3.438 1.688,3.646 0.188,0.208 10 false *1
*1 Oil Jet *2 Check Valve
*a Oil Jet Cross Section *b Engine Oil




c.

Oil Filter

i.

An oil filter with a replaceable element is used. The element uses a high-performance filter paper to improve filtration performance. It is also combustible for environmental protection.


ii.

An aluminum alloy filter cap is used to extend its life.


iii.

This oil filter has a structure which can drain the engine oil remaining in the oil filter. This prevents engine oil from spattering when replacing the element and allows the technician to work without touching hot engine oil.

W135232C01
0.583,2.667 0.917,2.667 0.917,2.667 1.333,2 true 0.583,3.75 0.917,3.75 0.917,3.75 1.333,3.083 true 0.583,4.833 0.917,4.833 0.917,4.833 1.333,4.25 true 0.583,5.167 1.5,5.167 true 2.833,3.417 3,3.417 3,3.417 3.5,2.917 true 2.833,3.917 3,3.917 3,3.917 3.417,3.417 true 3.917,3.688 3.917,4.354 true 5.833,3.833 5.25,3.833 true 5.719,4.333 5.552,4.833 5.552,4.833 5.302,4.833 true 0.406,2.563 0.604,2.771 0.198,0.208 10 false *1 0.406,3.646 0.583,3.865 0.177,0.219 10 false *2 0.406,4.74 0.615,4.948 0.208,0.208 10 false *3 0.406,5.073 0.635,5.271 0.229,0.198 10 false *4 5.063,3.719 5.271,3.958 0.208,0.24 10 false *5 5.073,4.729 5.302,4.979 0.229,0.25 10 false *6 5.771,4.698 5.969,4.896 0.198,0.198 10 false *a 2.667,3.302 2.844,3.521 0.177,0.219 10 false *2 2.656,3.823 2.865,4.031 0.208,0.208 10 false *3 3.865,4.385 4.094,4.583 0.229,0.198 10 false *4
*1 Oil Filter Case *2 Element
*3 Filter Cap *4 Drain Plug
*5 Drain Pipe *6 Hose (Inside Diameter: 15 mm (0.59 in.))
*a When draining engine oil - -


HINT:
·

The engine oil in the oil filter can be drained by removing the drain plug and inserting the drain pipe supplied with the element into the oil filter. For details, refer to the Repair Manual.

·

The engine oil maintenance interval for a model that has an oil filter with a replaceable element is the same as that for the conventional model.