OUTLINE
The exterior lights consist of the following:
| *1 | Side Turn Signal Light (RH) | *2 | Side Turn Signal Light (LH) |
| *3 | Headlight Assembly (LH) | *4 | Headlight Assembly (LH) |
| *5 | Accessory Light Assembly (RH) | *6 | Accessory Light Assembly (LH) |
| *a | Front Turn Signal Light | *b | Clearance Light |
| *c | Low Beam/High Beam | *d | Daytime Light/Accessory Light |
| *1 | Rear Light | *2 | Rear Combination Light |
| *3 | High Mount Stop Light | *4 | License Plate Light |
| *a | Stop Light | *b | Rear Turn Signal Light |
| *c | Taillight | *d | Back-up Light |
MAJOR DIFFERENCE
The new models have been modified from the previous models as shown below:
The exterior lights for AERAS has been changed.
The lighting system for AERAS has been modified.
SPECIFICATION
| Light | Type | Wattage [W] | |
|---|---|---|---|
| Headlight Assembly LH/RH | Low Beam/High Beam | LED x 4 | 29/34 |
| Front Turn Signal Light | Bulb (WY21W) | 21 | |
| Clearance Light | LED x 3 | 1.8 | |
| LED Illumination Light LH/RH | Daytime Light/Accessory Light | LED x 2 | 7.5/1.2 |
| Side Turn Signal Light | LED x 3 | 0.4 | |
| Rear Combination Light Assembly LH/RH | Taillight | LED x 1 | 1.2 |
| Stop Light | LED x 3 | 1.4 | |
| Rear Turn Signal Light | Bulb (WY21W) | 21 | |
| Rear Light Assembly LH/RH | Taillight | LED x 9 | 0.6 |
| Stop Light | LED x 12 | 1.2 | |
| Back-up Light | Bulb (W16W) | 16 | |
| High Mount Stop Light | LED x 6 | 2.2 | |
| License Plate Light Assembly (LH/RH) | T10 (Bulb) | 5 | |
PRECAUTION
HID Headlight System
When the HID headlights illuminate, a high voltage (approximately 20,000 V) is applied momentarily to the bulb sockets, which could lead to a serious accident. Never connect the tester to the high voltage socket of HID headlight for measurement, as this leads to a serious accident because of high voltage.
When performing operation related to the HID headlight, make sure to do it in the place with no water of rain to prevent electric shock, with the light control switch OFF, the battery terminal removed, the connector of the light control ECU disconnected.
When performing an operation related to the HID headlight, make sure to do it after assembling has been completely over and never light up without a bulb installed.
Do not light up the HID headlight using another power source except vehicle's.
When there is a defect on the HID headlight or any shock has been applied to it, replace the light with a new one.
A metal halide bulb reaches a high temperature when it is illuminated. For this reason, the life of the bulb could be shortened if any oil comes in contact with the glass portion of the bulb. Do not touch the glass portion of a bulb with bare hands.