CONSTRUCTION
Instead of constructing the armature coil with conventional type round-shaped conductor wires, the PS type starter uses square-shaped conductors. With this type of construction, the same conditions that are realized by winding numerous round-shaped conductor wires can be achieved without increasing the mass. As a result, the output torque has been increased, and the armature coil has been made more compact.
Because the surface of the square-shaped conductors that are used in the armature coil functions as a commutator, the overall length of the PS type starter has been shortened.
| *A | Conventional Type | *B | PS Type |
| *1 | Armature | *2 | Brush |
| *3 | Commutator | *4 | Surface Commutator |
| *5 | Square-shaped Conductor | *6 | Round-shaped Conductor |
| *a | A-A Cross Section | *b | B-B Cross Section |
Instead of the field coils used in the conventional type starter, the PS type starter uses two types of permanent magnets: the main magnets and the interpolar magnets. The main and interpolar magnets are arranged alternately inside the yoke, allowing the magnetic flux that is generated between the main and interpolar magnets to be added to the magnetic flux that is generated by the main magnets. In addition to increasing the amount of magnetic flux, this construction shortens the overall length of the yoke.
| *1 | Main Magnet | *2 | Yoke |
| *3 | Interpolar Magnet | *4 | Armature |
| *a | Cross Section of Yoke | *b | Magnetic Flux Generated by Relationship between Main Magnets |
| *c | Magnetic Flux Generated by Interpolar Magnets | - | - |