Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM
NM24M0E _58 Vehicle Interior _061450 DOOR LOCK _0302045 WIRELESS DOOR LOCK CONTROL SYSTEM UN GENERAL/CONTROL/DETAILS F

DOOR LOCK  WIRELESS DOOR LOCK CONTROL SYSTEM  GENERAL/CONTROL/DETAILS  DETAILS  


FUNCTION


a.

The wireless door lock remote control system has the following functions:

Function Outline

*1: Models with Power Slide Door System

*2: Models with Power Back Door System

All Doors Lock Pressing the lock button of the transmitter locks all doors and prohibits the electronic back door operation.
All Doors Unlock Pressing the unlock button of the transmitter unlocks all doors and recognizes the electronic back door operation.
Power Slide Door*1 Open/Close Keeping the power slide door button of the key-integrated type transmitter pressed longer than about 1 second opens or closes the power slide door.
Power Back Door*2 Open/Close Keeping the back door button of the key-integrated type transmitter pressed longer than about 1 second opens or closes the power back door.
Automatic Lock Function If none of the doors are opened within 30 seconds of them being unlocked by the wireless door lock remote control, all the doors are locked again automatically.
Answer Back The hazard light flashes once when locking, and the hazard light flashes twice when unlocking, to inform that the operation has been completed.
Transmitter Recognition Code Registration Function
·

A maximum of 4 types of transmitter recognition codes can be registered in the wireless door control receiver.

·

When 4 codes are already registered and a new code is registered, the oldest of the already registered codes is written over.


Customized Body Electronics For details, see (Click here).


b.

Transmitter Recognition Code Registration Function

i.

The table below shows the 4 special coded ID registration function modes through which up to 4 different codes can be registered. The codes are electronically registered (written and stored) in the EEPROM. For details of the recognition code registration procedure, refer to the Previa/Tarago Repair Manual.

Mode Function
Rewrite Mode Erases all previously registered codes and registers only the newly received codes.
Add Mode Adds a newly received code while preserving any previously registered codes. This mode is used when adding a new transmitter. If the number of codes exceeds 4, the oldest registered code is erased first.
Confirm Mode Confirms how many codes are currently registered. When adding a new code, this mode is used to check how many codes already exist.
If the number of codes exceeds 4, the oldest registered code is erased first.
Prohibit Mode Deletes all the registered codes and prohibits the wireless door lock function.This mode is used when the transmitter is lost.