OUTLINE
Along with the use of the smart entry & start system, a steering lock system which uses a lock/unlock motor to lock and unlock the steering wheel is used. This system mainly consists of the steering lock assembly, main body ECU, certification ECU and ID code box.
The steering lock ECU is integrated in the steering lock assembly, and it controls the lock bar operation in the steering lock assembly through the control of the lock/unlock motor.
The steering lock ECU detects the position (lock/unlock) of the lock bar and transmits this information to the main body ECU and certification ECU.
In this system, the certification ECU determines whether to lock or unlock the steering wheel based on communication with the main body ECU. Then, the certification ECU sends the lock or unlock request signal to the steering lock ECU through the ID code box. Upon receiving the signal, the steering lock ECU operates the lock/unlock motor to lock or unlock the steering wheel.
It is not possible to replace only the steering lock ECU in the steering lock assembly. Therefore, if a malfunction occurs in the ECU, the entire steering lock assembly must be replaced.
After a depleted battery is recharged, the engine may not start the first time (due to the steering lock ECU not correctly detecting the lock bar position).
When this happens, turn OFF all vehicle power supplies (ACC=OFF, IG=OFF), open and close the doors, and then start the engine again.