FUNCTION
The theft deterrent system has the following function:
| Function | Outline |
|---|---|
|
*: China Models |
|
| Alarm | When the theft deterrent system is switched to the alarm state, the warning item is operated for approximately 30 seconds/10seconds* and the alarm sounds. |
| Alarm Indicator | When the theft deterrent system is switched to the armed preparation or alarm state, the security indicator light is illuminated to inform the user.
This indicator is also the engine immobilizer indicator, which blinks in the engine immobilizer set state. |
| Forced Door Lock | The main body ECU transmits a door lock signal to all the doors when all the following conditions are satisfied.
·
The theft deterrent system is in the alarm state. ·
Key is not in the actuation area. ·
One of the front doors has been unlocked. The function stops when one of the following conditions is met. ·
All doors are locked. ·
The warning ends after approximately 30 seconds. ·
Key is in the actuation area. |
| Alarm Memory | In order to inform the user that the theft deterrent system has been switched to the alarm state, the main body ECU illuminates the taillight for 2 seconds when the system is switched to the disarmed state. |
OPERATION
This system activates as described in the diagram below when one of items places in the respective state.
| Condition | Item |
|---|---|
|
*: China Models |
|
| Condition (1) | ·
Engine switch is OFF. ·
When the doors, engine hood and back door are all closed, the entry lock function is used to lock all doors. |
| Condition (2) | When the doors, engine hood and back door are all closed and locked, and 30 seconds have elapsed. |
| Condition (3) | ·
When one of the doors, engine hood or back door is changed from "close" to "open". ·
When one of the doors, engine hood, or back door is changed from "lock" to "unlock". ·
When the engine switch is pushed. ·
When a terminal is disconnected from the battery and reconnected. |
| Condition (4) | ·
Any door, engine hood or back door is opened. ·
Any door is changed from "lock" to "unlock" through an operation other than the entry unlock function. ·
A terminal is disconnected from the battery and reconnected. |
| Condition (5) | ·
The entry unlock function is used to unlock the doors. ·
After the power source mode has been changed to IG-ON, 2 seconds have elapsed. |
| Condition (6) | After approximately 30 seconds/10 seconds* of the alarm time have elapsed. |