OPERATION
AIRBAG FOR FRONTAL COLLISION
There are three types of airbags for frontal collisions: driver, front passenger, and knee (for the driver) airbags. These airbags deploy simultaneously.
AIRBAG FOR SIDE/REAR SIDE COLLISION
The airbags for side collisions contain two types of airbags: side and curtain shield airbags. These airbags deploy simultaneously. The airbag for rear side collisions contains only the curtain shield airbag.
With the airbags for side collisions, if the side airbag sensor (for front side) and floor airbag sensors detect an impact, it informs the airbag sensor assembly, and the airbag sensor assembly causes the side and curtain shield airbags to be deployed simultaneously.
With the airbags for rear side collisions, if the side airbag sensors (for rear side), rear airbag sensor and floor airbag sensors detect an impact, that is informed to the airbag sensor assembly via the side airbag sensor (for front side), and the airbag sensor assembly causes the curtain shield airbags to be deployed.
CONSTRUCTION
Front Airbag Sensor
The electrical (acceleration sensor) type airbag sensor is used for front airbag sensor.
The acceleration sensor is enclosed in the front airbag sensor. Based on the deceleration of the vehicle during a front collision, a distortion is created in the sensor and converted into an electrical signal. Accordingly, the extent of the initial collision can be detected in detail.
SRS Knee Airbag
The knee airbag deploys simultaneously with the front airbags in a front collision. With the deployment of the knee airbag, the driver's lower part of the body is restricted, thus helping provide the excellent efficiency of the passenger protection by the seat belt and front airbag.
The knee airbag is installed below the driver seat instrument panel, and comprises the airbag door, inflator and bag.
Side Airbag Sensor, Rear Airbag Sensor and Floor Airbag Sensor
The deceleration sensor is enclosed in each side airbag sensor, rear airbag sensor and floor airbag sensor. Based on the deceleration of the vehicle during a side or rear side collision, a distortion is created in the sensor and converted into an electrical signal.
Curtain Shield Airbag
A rear side collision is detected by the side airbag sensor (for rear side) or rear airbag sensor and floor airbag sensors in order to deploy the curtain shield airbag. Each SRS airbag is a one-piece design, consisting of an inflator, a bag, and a cover.
DIAGNOSIS
If the airbag sensor assembly detects a malfunction in the SRS airbag system, the airbag sensor assembly stores the malfunction data in memory, in addition to illuminating the SRS warning light.
The airbag sensor assembly outputs malfunction data, 5-digit DTCs (Diagnostic Trouble Codes) or 2-digit DTCs, to the intelligent tester II or the SRS warning light.
There are 2 types of DTCs for the SRS airbag system: 5-digit and 2-digit.
The 5-digit DTC can be read by connecting an intelligent tester II to the DLC3.
The 2-digit DTC can be read through the blinking of the SRS warning light with the SST (09843-18040) connected to the TC and GND terminals of the DLC3.
If the SRS airbag deploys, the airbag sensor assembly will turn ON the SRS warning light. However, in contrast from the ordinary diagnosis function, a DTC will not be memorized. The SRS warning light can be turned OFF only by replacing the airbag sensor assembly with a new one.