OUTLINE
The 2AZ-FE engine models use the U241E automatic transaxle. The U241E automatic transaxle is compact and high-capacity 4-speed Super ECT (Electronic Controlled Transaxle).
A low-viscosity type transmission fluid (Toyota ATF Type WS) is used.
Shift control in uphill/downhill traveling is used.
A PVC (Polyvinyl Chloride) shift lever knob is provided as standard equipment for the DX grade.
A leather and woodgrain shift lever knob is provided as standard equipment for the GL grade, and is available as optional equipment for the DX grade of the LHD models.
A gate type shift lever is used for luxuriousness.
MAJOR DIFFERENCE
This manual has been modified from the previous manual as shown below:
The shift lock release button has been changed.
SPECIFICATION
Automatic Transaxle Assembly
|
*1: Counter Gear Ratio Included *2: Weight shows the figure with the fluid fully filled. |
||
| Transaxle Type | U241E | |
| Engine Type | 2AZ-FE | |
| Drive Type | 2WD | |
| Gear Ratio*1 | 1st | 3.943 |
| 2nd | 2.197 | |
| 3rd | 1.413 | |
| 4th | 1.020 | |
| Reverse | 3.145 | |
| Differential Gear Ratio | 2.923 | |
| Fluid Capacity | Liters (US qts, Imp. qts) | 8.1 (8.6, 7.2) |
| Fluid Type | Toyota ATF Type WS | |
| Weight (Reference)*2 | kg (lb) | 89 (196) |
| Transaxle Type | U241E | ||
| C1 | Forward Clutch | The No. of Discs | 5 |
| C2 | Direct Clutch | 3 | |
| C3 | U/D Direct Clutch | 3 | |
| B1 | 2nd Brake | 3 | |
| B2 | 1st & Reverse Brake | 5 | |
| B3 | U/D Brake | 3 | |
| F1 | No. 1 One-way Clutch | The No. of Sprags | 22 |
| F2 | U/D One-way Clutch | 15 | |
| Front Planetary Gear | The No. of Sun Gear Teeth | 43 | |
| The No. of Pinion Gear Teeth | 17 | ||
| The No. of Ring Gear Teeth | 77 | ||
| Rear Planetary Gear | The No. of Sun Gear Teeth | 31 | |
| The No. of Pinion Gear Teeth | 19 | ||
| The No. of Ring Gear Teeth | 69 | ||
| U/D Planetary Gear | The No. of Sun Gear Teeth | 32 | |
| The No. of Pinion Gear Teeth | 26 | ||
| The No. of Ring Gear Teeth | 83 | ||
| Counter Gear | The No. of Drive Gear Teeth | 50 | |
| The No. of Driven Gear Teeth | 51 | ||
Torque Converter Assembly
| Torque Converter Type | 3-element, 1-step, 2-phase |
| Stall Torque Ratio | 1.85 |