Home › General › INTRODUCTION › REPAIR INSTRUCTION › from 2016.05
RM24M0E _V1 General _059537 INTRODUCTION _0291663 REPAIR INSTRUCTION D

INTRODUCTION  REPAIR INSTRUCTION  INITIALIZATION  


System Name
Lighting System (w/ AFS)
Parking Assist Monitor System
Power Slide Door System
Power Back Door System

NOTICE:

After the engine switch is turned off, the navigation receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.


Procedures necessary when battery terminal is disconnected / reconnected
Necessary Procedures Procedure Details Effects / Inoperative Functions When Necessary Procedures are not Performed Notes
w/ AFS: Store steering angle sensor neutral point Drive the vehicle at more than 20 km/h (12mph) for more than 5 minutes on a straight road, with as little traffic congestion as possible. AFS Neutral point storage may also be performed manually (see page (Click here))
w/ Parking Assist Monitor System: Store steering angle neutral point When steering wheel is turned fully to the left and right while driving on a flat, level road, the steering angle neutral point is corrected.
·

Parking Assist Monitor System

·

Multi-display indicates "System initializing"


Neutral point storage may also be performed manually (see page (Click here))
Reset slide door closed position Close the slide door fully to turn off the courtesy switch
·

Power Slide Door

·

Slide Door Closer


If the slide door is closed when disconnecting the cable from the battery terminal, it is not necessary to reset it.
Initialize power back door Close the slide door fully to turn off the courtesy switch
·

Power Back Door

·

Back Door Closer


If the back door is closed when disconnecting the cable from the battery terminal, it is not necessary to reset it.