Home › General › SPECIFICATIONS › BRAKE › 2014.09–2016.05
RM24M0E _V1 General _059539 SPECIFICATIONS _0291739 BRAKE F

SPECIFICATIONS  BRAKE  SERVICE DATA  


Stop Light Switch
Stop light switch Resistance 1 - 2 Switch pin released Below 1 Ω
Resistance 1 - 2 Switch pin pushed in 10 kΩ or higher
Resistance 3 - 4 Switch pin released 10 kΩ or higher
Resistance 3 - 4 Switch pin pushed in Below 1 Ω

Brake Pedal Load Sensing Switch
Brake pedal load sensing switch Resistance 1 - 2 Brake pedal depressed Approx. 1 kΩ
Resistance 1 - 2 Brake pedal released Approx. 213 Ω

Brake Pedal
Brake pedal height from dash panel LHD (with VSC) 192.7 to 202.7 mm (7.587 to 7.980 in.)
LHD (without VSC) 198.0 to 208.0 mm (7.795 to 8.189 in.)
RHD (with VSC) 167.2 to 177.2 mm (6.583 to 6.976 in.)
RHD (without VSC) 171.8 to 181.8 mm (6.764 to 7.158 in.)
Stop light switch clearance 0.5 to 2.6 mm (0.020 to 0.102 in.)
Brake pedal free play 1.0 to 6.0 mm (0.039 to 0.236 in.)
Brake pedal reserve distance from dash panel LHD (with VSC) More than 131 mm (5.16 in.)
LHD (without VSC) More than 117 mm (4.61 in.)
RHD (with VSC) More than 103 mm (4.06 in.)
RHD (without VSC) More than 92 mm (3.62 in.)

Brake Fluid Level Warning Switch
Brake fluid level warning switch Resistance 1 - 2 Float up (Switch OFF) 10 kΩ or higher
Resistance 1 - 2 Float down (Switch ON) Below 1 Ω

Front Brake
Pad lining thickness Standard 12.0 mm (0.472 in.)
Minimum 1.0 mm (0.039 in.)
Disc thickness Standard 28.0 mm (1.102 in.)
Minimum 25.0 mm (0.984 in.)
Disc runout Maximum 0.05 mm (0.00197 in.)

Rear Brake
Pad lining thickness Standard 10.0 mm (0.394 in.)
Minimum 1.0 mm (0.039 in.)
Disc thickness Standard 10.0 mm (0.394 in.)
Minimum 8.5 mm (0.335 in.)
Disc runout Maximum 0.15 mm (0.00591 in.)