Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › SFI SYSTEM
RM24M0E _51 Engine / Hybrid System _059540 2GR-FE ENGINE CONTROL _0291770 SFI SYSTEM D

2GR-FE ENGINE CONTROL  SFI SYSTEM  CHECK MODE PROCEDURE  


HINT:

Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect the malfunctions that cannot be detected in normal mode.


NOTICE:

All the stored DTCs and freeze frame data are cleared if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the engine switch is turned from on (IG) to (ACC) or off while in check mode. Before changing modes, always check and note any DTCs and freeze frame data.


CHECK MODE PROCEDURE (Using an intelligent tester)


a.

Check and ensure the following conditions:

i.

Battery voltage is 11 V or higher.


ii.

Throttle valve is fully closed.


iii.

Shift lever is in P or N.


iv.

A/C switch is off.



b.

Turn the engine switch off.


c.

Connect the intelligent tester to the DLC3.


d.

Turn the engine switch on (IG).


e.

Turn the tester on.


f.

Enter the following menus: Powertrain / Engine / Utility / Check Mode.


g.

Switch the ECM from normal mode to check mode.


h.
A076900E64
2.042,0.427 2.948,0.656 0.906,0.229 10 false 0.13 seconds 1.917,1.833 2.823,2.063 0.906,0.229 10 false 0.13 seconds 0.135,0.781 0.427,0.979 0.292,0.198 10 false ON 0.135,1.448 0.427,1.646 0.292,0.198 10 false OFF

Check that the MIL flashes as shown in the illustration.


i.

Start the engine.


j.

Check that the MIL turns off.


k.

Simulate the conditions of the malfunction described by the customer.


l.

Check DTCs and freeze frame data using the tester.