Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › SFI SYSTEM
RM24M0E _51 Engine / Hybrid System _059540 2GR-FE ENGINE CONTROL _0291770 SFI SYSTEM D

2GR-FE ENGINE CONTROL  SFI SYSTEM  BASIC INSPECTION  


When the malfunction is not confirmed by the DTC check, troubleshooting should be carried out in all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following flowchart, the location of the problem can be found quickly and efficiently. Therefore, using this check is essential when engine troubleshooting.

1.CHECK BATTERY VOLTAGE


NOTICE:

Carry out this check with the engine stopped and the engine switch off.


Result:
Result Proceed to
11 V or more GO TO STEP 2
Below 11 V CHARGE OR REPLACE BATTERY



2.CHECK WHETHER ENGINE CRANKS


Result:
Result Proceed to
OK GO TO STEP 3
NG PROCEED TO PROBLEM SYMPTOMS TABLE



3.CHECK WHETHER ENGINE STARTS


Result:
Result Proceed to
OK GO TO STEP 4
NG GO TO STEP 6



4.CHECK AIR FILTER


a.

Visually check that the air filter is not excessively contaminated with dirt or oil.

Result:
Result Proceed to
OK GO TO STEP 5
NG REPLACE AIR FILTER




5.CHECK IDLING SPEED


Result:
Result Proceed to
OK GO TO STEP 6
NG TROUBLESHOOT IDLING SPEED AND PROCEED TO NEXT STEP



6.CHECK FUEL PRESSURE


Result:
Result Proceed to
OK GO TO STEP 7
NG TROUBLESHOOT FUEL PRESSURE AND PROCEED TO NEXT STEP



7.CHECK FOR SPARKS


Result:
Result Proceed to
OK PROCEED TO PROBLEM SYMPTOMS TABLE
NG TROUBLESHOOT SPARK AND PROCEED TO NEXT STEP