Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › SFI SYSTEM
RM24M0E _51 Engine / Hybrid System _059540 2GR-FE ENGINE CONTROL _0291770 SFI SYSTEM U

2GR-FE ENGINE CONTROL  SFI SYSTEM  FAIL-SAFE CHART  


If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily or stops fuel injection.

DTC Code Components Fail-Safe Operations Fail-Safe Deactivation Conditions
P0011, P0015, P0021 and P0025 VVT system
·

Idle up (control of combustion worsening).

·

Stopping fuel-cut control.


Pass condition detected
P0031, P0032, P0051, P0052, P101D and P103D Air fuel ratio sensor heater ECM turns off air fuel ratio sensor heater Engine switch off
P0037, P0038, P0057, P0058, P102D and P105D Heated oxygen sensor heater ECM turns off heated oxygen sensor heater Engine switch off
P0100, P0102 and P0103 Mass air flow meter sub-assembly ECM calculates ignition timing according to engine speed and throttle valve position Pass condition detected
P0110, P0112 and P0113 Intake air temperature sensor ECM estimates intake air temperature sensor to be 20°C (68°F) Pass condition detected
P0115, P0117 and P0118 Engine coolant temperature sensor ECM estimates engine coolant temperature sensor to be 80°C (176°F) Pass condition detected
P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P0607, P0657, P2102, P2103, P2111, P2112, P2118, P2119 and P2135 Electronic Throttle Control System (ETCS) ECM cuts off throttle actuator current and throttle valve returned to 6° throttle position by return spring
ECM then adjusts engine output by controlling fuel injection (intermittent fuel-cut) and ignition timing in accordance with accelerator pedal opening angle, to allow vehicle to continue running at minimal speed*
Pass condition detected and then engine switch turned off
P0327, P0328, P0332 and P0333 Knock control sensor ECM sets ignition timing to maximum retard Engine switch off
P0351, P0352, P0353, P0354, P0355 and P0356 Igniter ECM cuts fuel Pass condition detected
P2120, P2121, P2122, P2123, P2125, P2127, P2128 and P2138 Accelerator pedal position sensor Accelerator pedal position sensor has 2 sensor circuits: Main and Sub
If either of circuits malfunctions, ECM controls engine using the other circuit
If both of circuits malfunction, ECM regards accelerator pedal as being released. As a result, throttle valve is closed and engine idles
Pass condition detected and then engine switch turned off

HINT:

*: The vehicle can be driven slowly when the accelerator pedal is depressed firmly and slowly. If the accelerator pedal is depressed quickly, the vehicle may speed up and slow down erratically.