DESCRIPTION
The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.
If it is impossible to replicate the problem even though a DTC is detected, confirm the freeze frame data.
The ECM records engine conditions in the form of freeze frame data every 0.5 seconds. Using the intelligent tester, 5 separate sets of freeze frame data can be checked.
3 data sets before the DTC was stored.
1 data set when the DTC was stored.
1 data set after the DTC was stored.
These data sets can be used to simulate the condition of the vehicle around the time of the occurrence the malfunction. The data may assist in identifying the cause of the malfunction, and judging whether it was temporary or not.
LIST OF FREEZE FRAME DATA
| Tester Display | Measurement Item | Diagnostic Note |
|---|---|---|
| Vehicle Speed | Vehicle speed | Speed indicated on speedometer |
| Engine Speed | Engine speed | - |
| Calculate Load | Calculated load | Calculated load by ECM |
| Vehicle Load | Vehicle load | - |
| MAF | Mass air flow volume | If value is approximately 0.0 gm/sec:
·
Mass air flow meter power source circuit open or short ·
VG circuit open or short If value is 271.0 gm/sec or more: ·
E2G circuit open |
| Atmosphere Pressure | Atmospheric pressure | - |
| Coolant Temp | Engine coolant temperature | If value is -40°C (-40°F), sensor circuit open
If value is 140°C (284°F), sensor circuit shorted |
| Intake Air | Intake air temperature | If value is -40°C (-40°F), sensor circuit open
If value is 140°C (284°F), sensor circuit shorted |
| Engine Run Time | Accumulated engine running time | - |
| Initial Engine Coolant Temp | Engine coolant temperature at engine start | - |
| Initial Intake Air Temp | Intake air temperature at engine start | - |
| Battery Voltage | Battery voltage | - |
| Accel Sens. No. 1 Volt % | Absolute accelerator pedal position No. 1 | - |
| Accel Sens. No. 2 Volt % | Absolute accelerator pedal position No. 2 | - |
| Throttle Sensor Volt % | Absolute throttle position sensor No. 1 | - |
| Throttl Sensor #2 Volt % | Absolute throttle position sensor No. 2 | - |
| Throttle Sensor Position | Throttle sensor position | - |
| Throttle Motor DUTY | Throttle actuator | - |
| Throttle Position | Throttle position | When the engine stalls, is difficult to start, or idles roughly. |
| ISC Flow | Flow rate calculated using information from mass air flow meter sub-assembly | When the engine stalls, is difficult to start, or idles roughly. |
| ISC Position | Requested throttle opening amount calculated using ISC control | When the engine stalls, is difficult to start, or idles roughly. |
| ISC Feedback Value | ISC feedback amount | When the engine stalls, is difficult to start, or idles roughly. |
| ISC Learning Value | ISC learned air flow value | When the engine stalls, is difficult to start, or idles roughly. |
| Electric Load Feedback Val | Compensation flow rate according to electrical load | When the engine stalls, is difficult to start, or idles roughly. |
| Air Conditioner FB Val | Compensation flow rate according to air conditioner load | When the engine stalls, is difficult to start, or idles roughly. |
| PS Feedback Val | Compensation flow rate according to power steering load | When the engine stalls, is difficult to start, or idles roughly. |
| Low Revolution Control | Low engine speed control operation state | When the engine stalls, is difficult to start, or idles roughly. |
| Neutral Control | Neutral control operation state | When the engine stalls, is difficult to start, or idles roughly. |
| N Range Status | Shift lever N status | When the engine stalls, is difficult to start, or idles roughly. |
| Injector (Port) | Injection period of the No. 1 cylinder | - |
| Injection Volum (Cylinder 1) | Injection volume (cylinder 1) | - |
| Fuel Pump Speed Control | FUEL PMP relay status | - |
| Fuel Pump/Speed Status | Fuel pump status | - |
| EVAP (Purge) VSV | Purge VSV duty ratio | - |
| Evap Purge Flow | Purge flow | - |
| Purge Density Learn Value | Learning value of purge density | - |
| EVAP Purge VSV | Purge VSV | - |
| Target Air-Fuel Ratio | Target air fuel ratio | - |
| AF Lambda B1S1 | Fuel trim at air fuel ratio sensor (bank 1 sensor 1) | - |
| AF Lambda B2S1 | Fuel trim at air fuel ratio sensor (bank 2 sensor 1) | - |
| AFS Voltage B1S1 | Air fuel ratio sensor output voltage (bank 1 sensor 1) | - |
| AFS Voltage B2S1 | Air fuel ratio sensor output voltage (bank 2 sensor 1) | - |
| AFS Current B1S1 | Air fuel ratio sensor output current (bank 1 sensor 1) | - |
| AFS Current B2S1 | Air fuel ratio sensor output current (bank 2 sensor 1) | - |
| O2S B1S2 | Heated oxygen sensor output voltage (bank 1 sensor 2) | - |
| O2S B2S2 | Heated oxygen sensor output voltage (bank 2 sensor 2) | - |
| O2S Impedance B1S2 | Heated oxygen sensor impedance (bank 1 sensor 2) | - |
| O2S Impedance B2S2 | Heated oxygen sensor impedance (bank 2 sensor 2) | - |
| Short FT #1 | Short-term fuel trim (bank 1) | Short-term fuel compensation used to maintain air-fuel ratio at stoichiometric air-fuel ratio |
| Long FT #1 | Long-term fuel trim (bank 1) | Overall fuel compensation carried out in long-term to compensate for a continual deviation of short-term fuel trim from central valve |
| Total FT #1 | Total fuel trim (bank 1) | - |
| Short FT #2 | Short-term fuel trim (bank 2) | Short-term fuel compensation used to maintain air-fuel ratio at stoichiometric air-fuel ratio |
| Long FT #2 | Long-term fuel trim (bank 2) | Overall fuel compensation carried out in long-term to compensate for a continual deviation of short-term fuel trim from central valve |
| Total FT #2 | Total fuel trim (bank 2) | - |
| Fuel System Status #1 | Fuel system status (bank 1) | ·
OL (Open Loop): Has not yet satisfied conditions to go closed loop ·
CL (Closed Loop): Using air fuel ratio sensor as feedback for fuel control ·
OLDrive: Open loop due to driving conditions (fuel enrichment) ·
OLFault: Open loop due to detected system fault ·
CLFault: Closed loop but air fuel ratio sensor, which used for fuel control malfunctioning |
| Fuel System Status #2 | Fuel system status (bank 2) | ·
OL (Open Loop): Has not yet satisfied conditions to go closed loop ·
CL (Closed Loop): Using air fuel ratio sensor as feedback for fuel control ·
OLDrive: Open loop due to driving conditions (fuel enrichment) ·
OLFault: Open loop due to detected system fault ·
CLFault: Closed loop but air fuel ratio sensor, which used for fuel control malfunctioning |
| IGN Advance | Ignition advance | - |
| Knock Feedback Value | Feedback value of knocking | - |
| Knock Correct Learn Value | Correction learning value of knocking | - |
| Idle Spark Advn Ctrl #1 | Individual cylinder timing advance compensation amount (No. 1) | When the engine stalls, is difficult to start, or idles roughly. |
| Idle Spark Advn Ctrl #2 | Individual cylinder timing advance compensation amount (No. 2) | When the engine stalls, is difficult to start, or idles roughly. |
| Idle Spark Advn Ctrl #3 | Individual cylinder timing advance compensation amount (No. 3) | When the engine stalls, is difficult to start, or idles roughly. |
| Idle Spark Advn Ctrl #4 | Individual cylinder timing advance compensation amount (No. 4) | When the engine stalls, is difficult to start, or idles roughly. |
| Idle Spark Advn Ctrl #5 | Individual cylinder timing advance compensation amount (No. 5) | When the engine stalls, is difficult to start, or idles roughly. |
| Idle Spark Advn Ctrl #6 | Individual cylinder timing advance compensation amount (No. 6) | When the engine stalls, is difficult to start, or idles roughly. |
| ACIS VSV | Intake air control valve assembly for acoustic control induction system | - |
| VVT Control Status #1 | VVT control status (bank 1) | - |
| VVT Control Status #2 | VVT control status (bank 2) | - |
| VVT Advance Fail | VVT control failure status | - |
| Catalyst Temp B1S1 | Estimated catalyst temperature (bank 1 sensor 1) | - |
| Catalyst Temp B2S1 | Estimated catalyst temperature (bank 2 sensor 1) | - |
| Catalyst Temp B1S2 | Estimated catalyst temperature (bank 1 sensor 2) | - |
| Catalyst Temp B2S2 | Estimated catalyst temperature (bank 2 sensor 2) | - |
| Starter Signal | Starter signal | - |
| Starter Control | Starter control | - |
| Power Steering Signal | Power steering signal | - |
| Starter Relay | Starter relay | - |
| Power Steer. Sig. Record | Power steering signal | - |
| ACC Relay | ACC relay | - |
| Neutral Position SW Signal | Park/Neutral position switch assembly signal | - |
| Stop Light Switch | Stop light switch assembly | - |
| A/C Signal | A/C signal | - |
| Idle Up Signal | Idle up signal | - |
| Closed Throttle Position SW | Closed throttle position switch | - |
| Electrical Load Signal | Electrical load signal | - |
| Time after DTC Cleared | Cumulative time after DTC cleared | - |
| Distance from DTC Cleared | Accumulated distance after DTC cleared | - |
| Warmup Cycle Cleared DTC | Warm-up cycle after DTC cleared | - |
| TC and TE1 | TC and TE1 terminals of DLC3 | - |
| Ignition Trig. Count | Ignition count | - |
| Cylinder #1 Misfire Count | Cylinder #1 misfire count | - |
| Cylinder #2 Misfire Count | Cylinder #2 misfire count | - |
| Cylinder #3 Misfire Count | Cylinder #3 misfire count | - |
| Cylinder #4 Misfire Count | Cylinder #4 misfire count | - |
| Cylinder #5 Misfire Count | Cylinder #5 misfire count | - |
| Cylinder #6 Misfire Count | Cylinder #6 misfire count | - |
| All Cylinders Misfire Count | All cylinders misfire count | - |
| Misfire RPM | Engine speed when misfire occurs | - |
| Misfire Load | Engine load when misfire occurs | - |
| Misfire Margin | Margin to detect engine misfire | - |
| Engine Starting Time | Time elapsed before engine starts (interval between engine switch on (IG) and off) | When the engine stalls, is difficult to start, or idles roughly. |
| Engine Speed (Starter Off) | Engine speed when starter off | When the engine stalls, is difficult to start, or idles roughly. |
| Starter Count | Number of times starter turned on after engine switch on (IG) | When the engine stalls, is difficult to start, or idles roughly. |
| Run Dist of Previous Trip | Distance driven during previous trip | When the engine stalls, is difficult to start, or idles roughly. |
| Previous Trip Coolant Temp | Engine coolant temperature during previous trip | When the engine stalls, is difficult to start, or idles roughly. |
| Previous Trip Intake Temp | Intake air temperature during previous trip | When the engine stalls, is difficult to start, or idles roughly. |
| Engine Oil Temperature | Engine oil temperature (estimated temperature) | When the engine stalls, is difficult to start, or idles roughly. |
| Previous Trip Eng Oil Temp | Engine oil temperature during previous trip | When the engine stalls, is difficult to start, or idles roughly. |
| Ambient Temp for A/C | Ambient temperature for A/C | When the engine stalls, is difficult to start, or idles roughly. |
| Previous Trip Ambient Temp | Ambient temperature during previous trip | When the engine stalls, is difficult to start, or idles roughly. |
| Low Rev for Eng Start | History of low engine speed after engine start | - |
| Minimum Engine Speed | Minimum engine speed | When the engine stalls, is difficult to start, or idles roughly. |
| Electric Fan Motor | Electric fan motor | - |
| Idle Fuel Cut | Idle fuel cut prohibit | - |
| Idle Fuel Cut | Fuel cut at idle | ON: when throttle valve fully closed and engine speed over 2800 rpm |
| FC TAU | FC TAU | Fuel cut being performed with a very light load to prevent incomplete engine combustion |
| Received MIL from ECT | MIL status from ECT | - |
| Shift Position Sig from ECT | Shift position signal from ECT | - |
| A/T Oil Temp from ECT | ATF temperature from ECT | - |
| SPD (NO) | Output shaft speed | - |
| ECT Lock Up | ECT lock up | - |
| Shift SW Status (P Range) | Shift switch status (P range) | - |
| Shift SW Status (R Range) | Shift switch status (R range) | - |
| Shift SW Status (N Range) | Shift switch status (N range) | - |
| Sports Shift Up SW | Sports shift up switch status | - |
| Sports Shift Down SW | Sports shift down switch status | - |
| Sports Mode Selection SW | Sports mode selection switch status | - |
| Shift SW Status (D Range) | Shift switch status (D range) | - |