The engine control unit intercommunicates with the skid control ECU with the Controller Area Network (CAN).
If there is a problem in this intercommunication, the ECM sets a DTC.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0129 | Following conditions are met for 2 seconds (1 trip detection logic): (a)
Engine switch on (IG) (b)
Battery voltage is 10.5 V or more (c)
No intercommunication between engine control ECU and skid control ECU |
ECM |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the tester on.
Enter the following menus: Powertrain / Engine / DTC.
Read DTCs.
| Result | Proceed to |
|---|---|
| DTC U0129 is output | A |
| DTC U0129 and other DTCs are output | B |
A
B