1.REMOVE EFI RELAY
Remove the engine room No. 1 relay block cover.
Remove the EFI MAIN relay from the engine room No. 1 relay block.
2.INSPECT EFI RELAY
Measure the resistance of the EFI MAIN relay.
| Tester Connection | Specified Condition |
|---|---|
| 3 - 5 | 10 kΩ or higher |
| 3 - 5 | Below 1 Ω
(when battery voltage is applied to terminals 1 and 2) |
If the result is not as specified, replace the relay.
3.INSTALL EFI RELAY
Install the EFI relay to the engine room No. 1 relay block.
Install the engine room No. 1 relay block cover.