Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM24M0E _51 Engine / Hybrid System _059540 2GR-FE ENGINE CONTROL _0291782 ACCELERATOR PEDAL A

2GR-FE ENGINE CONTROL  ACCELERATOR PEDAL  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 78110K 2.REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTICE:
·

Avoid physical shock to the accelerator pedal sensor assembly.

·

Do not disassemble the accelerator pedal sensor assembly.

·

This accelerator pedal sensor assembly does not require lubrication.

·

Do not apply oil or other lubrication to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.



a.
A137221

Disconnect the accelerator pedal sensor connector.


b.

Remove the 2 bolts and accelerator pedal sensor.