Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › CAMSHAFT POSITION SENSOR
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291784 CAMSHAFT POSITION SENSOR G

2AZ-FE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSPECTION  


PROCEDURE

Hide 11102A 1.INSPECT CAMSHAFT POSITION SENSOR

A095265

a.

Measure the resistance of the sensor.

Standard resistance:
Tester Connection Condition Specified Condition
1 (G+) - 2 (G-) Cold 835 to 1,400 Ω
1 (G+) - 2 (G-) Hot 1,060 to 1,645 Ω


NOTICE:

The terms Cold and Hot refer to the temperature of the sensor. Cold is from -10 to 50°C (14 to 122 °F) and Hot is from 50 to 100°C (122 to 212°F).


If the result is not as specified, replace the camshaft position sensor.