Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291785 CRANKSHAFT POSITION SENSOR G

2AZ-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSPECTION  


PROCEDURE

Hide 11301K 1.INSPECT CRANKSHAFT POSITION SENSOR

A097451

a.

Measure the resistance of the sensor.

Standard resistance:
Tester Connection Condition Specified Condition
1 (NE+) - 2 (NE-) Cold 985 to 1,600 Ω
1 (NE+) - 2 (NE-) Hot 1,265 to 1,890 Ω


NOTICE:

The terms Cold and Hot refer to the temperature of the sensor. Cold is from -10 to 50°C (14 to 122°F) and Hot is from 50 to 100°C (122 to 212°F).


If the result is not as specified, replace the crankshaft position sensor.