Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › from 2016.05
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291785 CRANKSHAFT POSITION SENSOR A

2AZ-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 27020 1.REMOVE GENERATOR ASSEMBLY

Hide 11301K 2.REMOVE CRANK POSITION SENSOR

a.
A192489

Disconnect the crank position sensor connector.


b.
A194008

Disconnect the connector from the connector bracket.


c.

Disconnect the 2 wire harness clamps.


d.

Remove the bolt and crank position sensor.