Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › EFI RELAY
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291787 EFI RELAY G

2AZ-FE ENGINE CONTROL  EFI RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85910F 1.REMOVE EFI RELAY (Marking: EFI MAIN)

a.

Remove the engine room No. 1 relay block cover.


b.

Remove the EFI MAIN relay from the engine room No. 1 relay block.


Hide 85910F 2.INSPECT EFI RELAY

a.
B426341E10
2.646,0.74 3,0.74 false 2.531,1.125 3,1.125 false 2.531,1.625 3,1.625 false 1.708,0.75 2,0.75 false 0.24,0.76 0.458,0.979 0.219,0.219 10 false 3 0.229,1.323 0.448,1.542 0.219,0.219 10 false 2 1.198,0.76 1.417,0.979 0.219,0.219 10 false 5 1.177,1.323 1.396,1.542 0.219,0.219 10 false 1 1.563,0.667 1.781,0.885 0.219,0.219 10 false 1 3.021,1.031 3.24,1.25 0.219,0.219 10 false 5 3.021,1.542 3.24,1.76 0.219,0.219 10 false 3 3.031,0.656 3.25,0.875 0.219,0.219 10 false 2

Measure the resistance of the EFI MAIN relay.

Standard resistance:
Tester Connection Specified Condition
3 - 5 10 kΩ or higher
3 - 5 Below 1 Ω
(when battery voltage is applied to terminals 1 and 2)


If the result is not as specified, replace the relay.


Hide 85910F 3.INSTALL EFI RELAY