To reduce hydrocarbon (HC) emissions, evaporated fuel from the fuel tank is routed through a charcoal canister to the intake manifold for combustion in the cylinders.
The ECM changes the duty signals to the purge VSV so that the intake amount of hydrocarbon (HC) emissions is appropriate for the driving conditions (engine load, engine speed, vehicle speed, etc.) after the engine is warmed up.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0443 | Both of the following conditions (a) and (b) are met (1 trip detection logic):
(a) The target control value and actual control value do not match for 10 seconds or more. (b) The target control value and actual control value do not match for 80 times or more. |
·
Open or short in purge VSV circuit ·
Purge VSV ·
ECM |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Read freeze frame data using the GTS. Freeze frame data records the engine conditions when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Remove the purge hose (on the canister side) of the purge hose.
Start the engine and turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for Evap Control.
When the purge VSV is operated using the GTS, check whether the port of the purge VSV applies suction to your finger.
| GTS Operation | Specified Condition |
|---|---|
| VSV is ON | Applies suction to finger |
| VSV is OFF | Applies no suction to finger |
NG
OK
Inspect the purge VSV (See page Engine / Hybrid System>2AZ-FE EMISSION CONTROL>VACUUM SWITCHING VALVE>INSPECTION).
OK
NG
Disconnect the purge VSV connector.
Turn the engine switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| D50-1 - Body ground | Engine switch on (IG) | 11 to 14 V |
OK
NG
Disconnect the purge VSV connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| D50-2 - D2-49 (PRG) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| D50-2 or D2-49 (PRG) - Body ground | Always | 10 kΩ or higher |
OK
NG