The battery temperature sensor installed on the battery current sensor detects battery temperature.
A thermistor is integrated into the battery temperature sensor, and the resistance in the battery temperature sensor changes according to the battery temperature.
The resistance of the thermistor in the battery temperature sensor decreases as the battery temperature increases. The resistance increases as the temperature decreases.
The battery temperature sensor is connected to the ECM. The ECM supplies 5 V from the THB terminal to the battery temperature sensor through resistor R.
The battery temperature sensor and resistor R are connected in series. This results in fluctuations in the voltage supplied from the THB terminal when the resistance changes according to the battery temperature.
The ECM determines the battery temperature according to fluctuations in voltage. When the battery temperature is high, the ECM determines to reduce the amount of current supplied from the generator in order to protect the battery.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0516 | Battery temperature sensor output value is 0.2 V or less for 0.5 seconds or more with the engine switch on (IG)
(1 trip detection logic) |
·
Battery temperature sensor ·
Short in battery temperature sensor circuit ·
ECM |
| P0517 | Battery temperature sensor output value is 4.8 V or more for 0.5 seconds or more with the engine switch on (IG)
(1 trip detection logic) |
·
Battery temperature sensor ·
Open in battery temperature sensor circuit ·
ECM |
Refer to DTC P1550 (see page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>SFI SYSTEM>P1550).
Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
Inspect the battery current sensor (See page Engine / Hybrid System>2AZ-FE CHARGING>BATTERY CURRENT SENSOR>ON-VEHICLE INSPECTION).
OK
NG
Disconnect the battery current sensor connector.
Disconnect the ECM connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A2-1 (THB) - D2-120 (THB) | Always | Below 1 Ω |
| A2-4 (E2) - D2-92 (EIB) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A2-1 (THB) or D2-120 (THB) - Body ground | Always | 10 kΩ or higher |
OK
NG