The battery current sensor installed on the positive (+) battery terminal detects the amount of current supplied from the generator.
The battery current sensor changes current to voltage (at the positive (+) battery terminal) and sends it to the ECM. The ECM controls the voltage of the generator based on the signals from the battery current sensor.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P1550 | The following condition continues for 10 seconds or more with the engine switch on (IG)
(1 trip detection logic): ·
Difference between the maximum and minimum current values of the battery current sensor is 1 A or less |
·
Open or short in battery current sensor circuit ·
Battery current sensor ·
ECM |
| P1551 | Battery current sensor output voltage is 0.2 V or less for 0.5 seconds or more with the engine switch on (IG)
(1 trip detection logic): |
·
Short in battery current sensor circuit ·
Battery current sensor ·
ECM |
| P1552 | Battery current sensor output voltage is 4.8 V or more for 0.5 seconds or more with the engine switch on (IG)
(1 trip detection logic): |
·
Open in battery current sensor circuit ·
Battery current sensor ·
ECM |
Read freeze frame data using the GTS. Freeze frame data records the engine conditions when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
Inspect the battery current sensor (See page Engine / Hybrid System>2AZ-FE CHARGING>BATTERY CURRENT SENSOR>ON-VEHICLE INSPECTION).
OK
NG
Disconnect the battery current sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A2-3 (IB) - D2-68 (IB) | Always | Below 1 Ω |
| A2-2 (VC5) - D2-69 (VCIB) | Always | Below 1 Ω |
| A2-4 (E2) - D2-92 (EIB) | Always | Below 1 Ω |
| A2-1 (THB) - D2-120 (THB) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A2-3 (IB) or D2-68 (IB) - Body ground | Always | 10 kΩ or higher |
| A2-2 (VC5) or D2-69 (VCIB) - Body ground | Always | 10 kΩ or higher |
| A2-1 (THB) or D2-120 (THB) - Body ground | Always | 10 kΩ or higher |
OK
NG