Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › SFI SYSTEM › from 2016.05
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291789 SFI SYSTEM C

2AZ-FE ENGINE CONTROL  SFI SYSTEM  P1602  Deterioration of Battery  


DESCRIPTION

The ECM determines the battery power according to the voltage of the BATT terminal while the engine is running (not cranking).

DTC No. DTC Detection Condition Trouble Area
P1602 Battery voltage is low for 10 seconds or more when the engine is running (not cranking) (1 trip detection logic)
·

Battery

·

ECM back-up power source circuit



WIRING DIAGRAM

A193164E25
1.958,1.271 2.604,1.438 0.646,0.167 10 false F/B BATT 3.531,1.26 3.792,1.417 0.26,0.156 10 false EFI 1.156,2.313 1.625,2.458 0.469,0.146 10 false Battery 5.292,0.938 5.49,1.083 0.198,0.146 10 false 20 5.281,1.125 5.5,1.292 0.219,0.167 10 false A7 5.219,2.167 5.479,2.354 0.26,0.188 10 false 104 5.281,2.365 5.479,2.51 0.198,0.146 10 false D2 5.583,1.125 5.979,1.281 0.396,0.156 10 false BATT 5.583,2.375 5.771,2.521 0.188,0.146 10 false E1 5.896,3.229 6.26,3.375 0.365,0.146 10 false ECM 1.042,1.656 1.688,1.823 0.646,0.167 10 false FL MAIN

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


HINT:

Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK ANY OTHER DTCS OUTPUT (DTC P1602)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


e.

Read the DTCs.

Result
Result Proceed to
DTC P1602 is output A
DTC P1602 and other DTCs are output B

HINT:

If any DTCs other than P1602 are output, troubleshoot those DTCs first.




A

2.CHECK CHARGING SYSTEM

B

2.CHECK CHARGING SYSTEM

OK

3.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

NG

REPAIR OR REPLACE CHARGING SYSTEM

3.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
a.

Disconnect the ECM connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A7-20 (BATT) - Body ground Always 11 to 14 V




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR