Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › SFI SYSTEM › 2013.04–2014.09
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291789 SFI SYSTEM D

2AZ-FE ENGINE CONTROL  SFI SYSTEM  DTC CHECK / CLEAR  


NOTICE:

When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data that were recorded in normal mode are erased. Before changing modes, always check and make a note of any DTCs and freeze frame data,


HINT:
·

DTCs which are stored in the ECM can be displayed on the intelligent tester. The intelligent tester can display both current and pending DTCs.

·

Malfunctions that were not detected a second time by the ECM during the second driving cycle are stored as pending DTCs.



CHECK DTC (Using intelligent tester)


a.

Connect the intelligent tester to the DLC3.


b.

Turn the engine switch on (IG) and turn the tester on.


c.

Enter the following menus: Powertrain / Engine and ECT / DTC.


d.

Check the DTC(s) and freeze frame data, and then write them down.




CLEAR DTC (Using intelligent tester)


a.

Connect the intelligent tester to the DLC3.


b.

Turn the engine switch on (IG) and turn the tester on.


c.

Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.


d.

Press the YES button.



CLEAR DTC (Without using intelligent tester)


a.

Perform either of the following operations.

i.

Disconnect the cable from the negative (-) battery terminal for more than 1 minute.


ii.

Remove the EFI and ETC-S fuses from the No. 1 engine room relay block (located inside the engine compartment) for more than 1 minute.