DTC P0630 is stored when the Vehicle Identification Number (VIN) or frame number is not stored in the ECM or the stored VIN or frame number is not accurate.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0630 | Either of the following conditions is met (1 trip detection logic):
·
The VIN or frame number is not stored in the ECM. ·
The VIN or frame number written to the ECM is not accurate. |
ECM |
Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help mine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P0630 is output | A |
| DTC P0630 and other DTCs are output | B |
If P0630 is output, the VIN or frame number must be written to the ECM using the GTS. However, all DTCs are cleared automatically by the GTS when the VIN or frame number is written. If DTCs other than P0630 are output, troubleshoot them first.
A
B
Write the VIN or frame number (See page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>SFI SYSTEM>REGISTRATION).
NEXT