Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › SFI SYSTEM › from 2016.05
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291789 SFI SYSTEM C

2AZ-FE ENGINE CONTROL  SFI SYSTEM  P0604  Random Access Memory (RAM)  P0606  ECM / PCM Processor  P0607  Control Module Performance  P060A  Internal Control Module Monitoring Processor Performance  P060D  Internal Control Module Accelerator Pedal Position Performance  P060E  Internal Control Module Throttle Position Performance  P0657  Actuator Supply Voltage Circuit / Open  P1607  Cruise Control Input Processor  


DESCRIPTION

The ECM continuously monitors its internal memory status, internal circuits, and output signals transmitted to the throttle actuator. This self-check ensures that the ECM is functioning properly. If any malfunction is detected, the ECM sets the appropriate DTC and illuminates the MIL.

The ECM memory status is diagnosed by internal "mirroring" of the main CPU and the sub CPU to detect Random Access Memory (RAM) errors. The 2 CPUs also perform continuous mutual monitoring. The ECM illuminates the MIL and set a DTC if: 1) outputs from the 2 CPUs are different or deviate from the standards, 2) the signals sent to the throttle actuator deviate from the standards, 3) a malfunction is found in the throttle actuator supply voltage, and 4) any other ECM malfunction is found.

DTC No. DTC Detection Condition Trouble Area
P0604
P0606
P0607
P060A
P060D
P060E
P0657
P1607
ECM internal error (1 trip detection logic) ECM

CAUTION / NOTICE / HINT

NOTICE:

After turning engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine conditions when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK ANY OTHER DTCS OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG) and turn the GTS on.



d.

Turn the engine switch off and turn the GTS off.


e.

Disconnect the GTS.


f.

Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.


g.

Connect the cable to the negative (-) battery terminal.


h.

Connect the GTS to the DLC3.


i.

Turn the engine switch on (IG) and turn the GTS on.


j.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


k.

Read the DTCs.


Result:
Result Proceed to
DTC P0604, P0606, P0607, P060A, P060D, P060E, P0657 and/or P1607 are output A
DTC P0604, P0606, P0607, P060A, P060D, P060E, P0657, P1607 and other DTCs are output B
DTC is not output C



A

B

C