Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › THROTTLE BODY
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291793 THROTTLE BODY G

2AZ-FE ENGINE CONTROL  THROTTLE BODY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 22210 1.CHECK THROTTLE BODY

a.

Check the throttle control motor operating sounds.

i.

Turn the ignition switch on (IG).


ii.

When depressing the accelerator pedal, check the operating sound of the running motor. Make sure that no friction noises emit from the motor.

If friction noise exists, replace the throttle body.



b.
B135940E01
0.425,2.845 1.557,3.021 1.132,0.177 10 Intelligent Tester 0.6,2.589 0.6,2.832 false 1.48,2.058 1.864,2.214 0.385,0.156 10 DLC3 1.717,2.051 1.841,1.732 false

Check the throttle position sensor.

i.

Connect the intelligent tester to the DLC3.


ii.

Turn the ignition switch on (IG).


iii.

Push the intelligent tester main switch ON.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Position Sensor.


v.

Depress the accelerator pedal. When the throttle valve is fully opened, check that the value of "Throttle Position Sensor" is within the specification.

Standard throttle valve opening percentage:

60% or more


NOTICE:

When checking the standard throttle valve opening percentage, the shift lever should be in the N position.


If the percentage is less than 60%, replace the throttle body.