Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291795 ACCELERATOR PEDAL A

2AZ-FE ENGINE CONTROL  ACCELERATOR PEDAL  REMOVAL  


PROCEDURE

Hide 28800 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 78110K 2.REMOVE ACCELERATOR PEDAL ROD ASSEMBLY

NOTICE:
·

Avoid physical shock to the accelerator pedal.

·

Do not disassemble the accelerator pedal assembly.

·

This accelerator pedal does not require lubrication.

·

Do not apply oil or other lubrication to the accelerator pedal. If applied, the accelerator pedal must be replaced.



a.
A137221

Disconnect the accelerator pedal position sensor connector.


b.

Remove the 2 bolts and accelerator pedal rod.