Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291795 ACCELERATOR PEDAL G

2AZ-FE ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78010F 1.CHECK ACCELERATOR PEDAL ROD

a.
B135940E01
0.425,2.845 1.557,3.021 1.132,0.177 10 Intelligent Tester 0.6,2.589 0.6,2.832 false 1.48,2.058 1.864,2.214 0.385,0.156 10 DLC3 1.717,2.051 1.841,1.732 false

Check the voltage.

i.

Connect the intelligent tester to the DLC3.


ii.

Turn the ignition switch on (IG).


iii.

Turn the intelligent tester ON.


iv.

Select the menu items: Powertrain / Engine and ECT / Data List / All Data / Accelerator Position No. 1, Accelerator Position No. 2.


v.

Operate the accelerator pedal, and then check that the Accelerator Position No. 1 and Accelerator Position No. 2 values are within the specifications.

Standard voltage:

Accelerator Position No. 1

Accelerator Pedal Condition Specified Condition
Released 0.5 to 1.1 V
Depressed 2.5 to 4.5 V


Accelerator Position No. 2:
Accelerator Pedal Condition Specified Condition
Released 1.2 to 2.0 V
Depressed 3.4 to 5.0 V


If the result is not as specified, check the accelerator pedal rod, wire harness or ECM.