Do not do anything which may separate the fuel tube from either the fuel suction plate or fuel filter assembly, such as applying excessive force to the tube.
83320
1.REMOVE FUEL SENDER GAUGE ASSEMBLY
Remove the 2 harness protectors from the wire harness.
Do not damage the wire harness.
Disconnect the connector of the fuel sender gauge assembly.
Disconnect the wire harness from the 4 harness clamps.
Do not damage the wire harness.
Release the lock as shown in the illustration and slide the fuel sender gauge assembly to remove it.
2.REMOVE FUEL SUB-TANK ASSEMBLY
Disconnect the wire harness connector.
Separate the wire harness.
Detach the 2 claws and remove the sub-tank.
Using a screwdriver, remove the jet pump.
Tape the screwdriver tip before use.
Remove the O-ring from the jet pump.
| *1 | Jet Pump |
| *2 | O-ring |
3.REMOVE BRACKET
Using a screwdriver, detach the 2 claws and remove the bracket.
Tape the screwdriver tip before use.
23221
4.REMOVE FUEL PUMP ASSEMBLY
Detach the 5 claws on the filter and remove the fuel pump from the fuel filter.
| *1 | Fuel Filter |
| *2 | Suction Filter |
Do not damage the fuel suction filter and fuel filter.
Do not remove the fuel suction filter from the fuel pump.
If the fuel filter assembly is to be replaced, replace the fuel suction plate sub-assembly.
Disconnect the fuel pump connector.
Remove the O-ring and spacer from the fuel pump.
| *1 | O-ring |
| *2 | Fuel Pump Spacer |
| *a | 5.0 mm (0.197 in.) |
Be careful not to damage the sealing surface.
If the O-ring still remains in the fuel filter, remove it using a wire tip (φ1 mm) that is formed as shown in the illustration.
23280J
5.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY
Remove the pressure regulator from the fuel filter.
Remove the 2 O-rings.